Root Galaxy Note 10.1 N8010 XXUCMA8 Android 4.1.2 Jelly Bean Update

Here’s a root method that works for Samsung Galaxy Note 10.1 Wi-Fi (GT-N8010) that already gets an upgrade to Android 4.1.2 Jelly Bean with build numbers such as N8010XXUCMA8 or the earlier N8010XXUCMA5. This update was released in Australia and in selected Europe countries.

There are two rooting methods that I have prepared, which you can choose the one that you may find it easy for you to root your Galaxy Note N8010.

The below rooting process includes using SuperSU with CWM recovery (touch/non-touch) and or using CF-AUTO Root. So, just follow each steps of which method you are about to apply onto your Galaxy Note 10.1 N8010.

Again, this rooting process on works for Samsung Galaxy Note 10.1 GT-N8010 devices currently running on Android 4.1.2 Jelly Bean and should not be used on other Samsung Android devices.

You can check your device firmware details via Settings>> About device>> Software Info.
Check if it’ll match the following Android 4.1.2 firmware build versions;

  • N8010XXUCMA8
  • N8010XXUCMA5


Disclaimer: Rooting will voids the warranty of your device. Use of this guide is solely at your own risk. The developer of this root methods and including us shall not be held responsible if anything happens to your device.

Method 1: Root Galaxy Note 10.1 N8010 WiFi using CF-AUTO Root

Using CF-AUTO Root on your Samsung Galaxy Note 10.1 is too easy for beginners, this rooting process does not requires custom recovery to install and it usually retain the stock recovery once installed. That means your device runs closer to factory stock and can receive future firmware updates.
Download the following files:
CF-Root for Galaxy Note 10.1  N8010 download
Grab odin flasher tool Download
Install USB driver Download

  • Make sure the battery is fully charge.
  • Make a back-up copy of all important files stored from the device such as contacts, messages, photos videos etc. just to be safe.
  • Enable USB debugging mode of your Galaxy Note 10.1 Go to Settings>Application>Development>Turn On USB debugging mode.

1) Unzip or extract the downloaded ( Then you will get the (CF-Auto-Root-p4notewifiww-p4notewifixx-gtn8010.tar.md5) which now a Odin flashable file.
2) Run Odin Odin3 v3.07.exe or v1.85.exe in your computer

3) In Odin options, make sure the “Re-Partition is unchecked. Leave Auto Reboot and F. Reset Time checkboxes are checked.

4) Reboot the Galaxy Note 10.1 into download. To enter Download Mode – Turn it OFF then just “press and Hold the Volume Down button and Power button”. Simply press volume up to continue, once the warning screen appears.

5) Connect your Galaxy Note 10.1 to the computer via USB cable. You should see that Odin will highlight the ID:COM bar and it says “Added!!”. If Odin doesn’t respond while plugging-in the device, just check for possible issues like re-installing the USB driver and or checking the USB cable.

6) Click the PDA Button,then browse and select the “CF-Auto-Root-p4notewifiww-p4notewifixx-gtn8010.tar.md5” file to load it.

Odin Install CF Auto Root Samsung Galaxy Note 10.1 N8010

7) Simply Hit the START button to begin the root process.

8)  Wait until it finishes and or until a word “PASS!” displays in Odin and then let the device completely reboots.

9) Then unplugged the phone from the computer.

Method 2: Root Galaxy Note 10.1 N8010 WiFi using CWM Recovery and SuperSU

This method requires a custom recovery such as CWM Recovery, once the CWM recovery installed you can then manually flash the SuperSU root files  unto it.  The CWM recovery functions is useful on most cases like making a back-up from your device stuffs, installing ROMs etc.

Download following needed files:
CWM Touch Recovery  Download (It’s actually N8000 but will also works for N8010, from XDA-developers)
SuperSU 1.04 download

1) Copy the on your device SD card.

2) Flash the CWM recovery via Odin, use the same process as above installation of the CF-Auto Root in Odin.

Odin Install CWM recovery Samsung Galaxy Note 10.1 N800,N8010, N8013

3) After the CWM recovery installed reboot the device onto recovery options.

4) Press and hold Power and Volume Up Button. It will then turns off and reboot,

5) Once the Galaxy Note 10.1 screen logo appears, release the On/Off Button and hold Volume Up,

6) Scroll down to “install zip from sd-card” option,

install zip

7) Choose zip from sd-card and navigate to the folder where you placed the,

8) Select “YES” to install,
9) Select “Go back”” and Reboot system,

Once finishes, you should then see that your device is rooted with SuperSU.

How to Reset Galaxy Note 10.1 N8010 Binary Flash counter

Rooting your Samsung Galaxy Note 10.1 ignites the binary flash counter to custom, you may only reset it using the triangle away apps. Grab Triangle Away, just follow the steps from apps menu once installed.

Does this root methods work on your Samsung Galaxy Note 10.1 N8010? Which root method did you use?